Hello guys, I wasted one day try config port for my ip.
In my house I have one modem that sends link for mikrotik, and mikrotik send internet for my computer.

I use this command and try manually too.

/ip firewall nat
add chain=dstnat action=dst-nat in-interface="ether1, WAN IP" dst-port=16000 to-addresses=myipv4 to-ports=16000 protocol=udp

I try open port 16000 in modem too, but dont work with my ipv4. I think why my ipv4 its generated for mikrotik

The following below should work without any problems.

[You must login to view link]

Please also make sure, that the rule was properly saved and applied to your Mikrotik router + rebooted.

I write this code on terminal like u say:
/ip firewall nat add chain=dstnat dst-port=16000 action=dst-nat protocol=udp to-address=<my ipv4> to-port=16000

and reboot mikrotik.
but i dont made anything on moden.

but dont solve problem

check attachment

Keep UPnP disabled please.

hi
turn off UPnP on the router and in the voobly settings. save/apply.
using this dhcp and step1 find the private ip of your pc and use in the port forwarding. apply/save: https://www.voobly.com/pages/view/134
[You must login to view link]

Hello, i fix problem.
I connect direct in modem and open port
Thanks for attention.

hi
ok